China’s first electric commercial airliner has flown on an all-domestic power system: ten distributed ducted-fan propulsion motors developed by the Institute of Electrical Engineering at the Chinese Academy of Sciences delivered 2 megawatts in total to COMAC’s CE-25A during the aircraft’s first crewed intelligent flight, the academy said on November 18.
The flight took place at Binzhou in Shandong province on November 14, with two pilots and a flight test engineer aboard. It followed an uncrewed first flight on February 2 and 19 autonomous test sorties, and the Civil Aviation Administration of China has accepted an application for the aircraft’s type certificate.
The CE-25A is designed for short intercity routes: 19 passengers, a maximum take-off weight of 10 tonnes, a cruise speed of 300 kilometres per hour at 2,400 metres and a range of 400 kilometres. It is being developed by COMAC together with battery supplier CATL, Shanghai Jiao Tong University and other partners.
The hard part is weight. Electric aviation demands a very high power-to-weight ratio, and air cooling normally struggles to remove heat from dense high-power electronics. The institute chose forced air cooling using the duct’s own airflow, and integrated the motor and converter into one unit, avoiding the pumps, hoses and coolant that a liquid-cooled design would add.
The team reports an energy efficiency of 94.5 percent along the flight profile and a power-to-weight ratio of 4.34 kilowatts per kilogram, 79.3 percent above the 2.42 kW/kg figure for Safran’s certified benchmark unit, which the academy describes as the largest airborne distributed propulsion system in service today. Manufacturing was carried out by Xiangtan Electric Manufacturing.
For readers outside China, the interest is in what this says about the electric aircraft race. Mature air-cooled electric propulsion products have generally stayed near or below 100 kilowatts per unit, so a 2-megawatt array is a step beyond what has flown before, even though 19 seats and 400 kilometres place the aircraft firmly in the regional, not mainline, market.
Certification will decide whether that translates into service. Battery energy density limits range, and regulators will want evidence on thermal runaway, redundancy after motor failure and the crashworthiness standards that apply to transport-category aircraft.

Dgcity